United Bicycle Institute
TECHNICAL FORUM
UBI Main Page
UBI Courses and Schedules

[ Post a Reply ] [ UBI Technical Forum ] [ FAQ ]

Subject: Re: Creaks
Posted by: Rob on August 22, 2006 at 09:07:55:
In Reply to: Creaks posted by Dave S on August 18, 2006 at 12:17:13:

Message:
>I hate to ask since this topic has appeared many times before, but here it goes anyway....

>I have a creaking sound when pedaling hard, mostly when in the 6,7,8th gears, but not limited to these. My bike is a Cannondale R3000si, with Campy Chorus 10sp. The components have approximately 8,100 miles on them, so are relatively new. I have done the following
>-removed bottom bracket, regreased, torqued to spec.
>-removed chainrings, cleaned, torqued to spec.
>-removed cassette, cleaned, torqued to spec.
>-replaced chain.
>-removed seatpost, cleaned, lubed.
>-removed pedals, overhauled.
>-installed rear wheel with appropriatly tight QR.
>I am an experienced mechanic, but am at a loss on this one. Any suggestions are appreciated.


Headsets can creak as well as some stem/bar combinations. My experience was a seatpost clamp that creaked until I had to really tighten it up hard and some peadals that creaked on and off till tightened them on hard.





Post a Follow Up To This Message

Name:  
E-Mail:
Subject:

Follow Up Message:


[ UBI Technical Forum ] [ FAQ ]