Subject: Re: Al frame drilling, epoxi, etc Posted by: arash on September 29, 2006 at 22:16:20: In Reply to: Re: Al frame drilling, epoxi, etc posted by Dave. on December 19, 2003 at 10:12:38:

Message: >>>I would like to modify a Giant Ocr frame to run top tube cable for shifting, and have been thinking about the best way to install the cable guides: drilling and rivets, soldering (low temp) or using epoxi. Any thoughts? >>You can't solder aluminum ... >>I would be cautious about drilling holes in an aluminum frame BECAUSE you would want to be careful as to WHERE you did it and HOW you "filled" the hole ... a rivet seems dubious for various reasons. >>I would TRY epoxying the guide in place first. >>If the guide has a mounting pin, then I would THEN consider drilling & epoxy. >>The real question is WHY DO YOU WANT TO DO THIS? >>You will need to add at least two guides to the top PLUS one for the seat tube. >>The guide/stop on the seat tube will be under a fair amount of stress ... >> >You might try clamp-on cable stops. This would be non-destructive method of accomplishing your goal, probably much easier, cheaper, less risky, and reversible. Tektro makes them for example.